Filter type dust collector refers to the equipment that realizes gas-solid separation when dust particles in the airflow are intercepted and captured by the filter layer when the dust-containing smoke holes pass through the filter layer. Filter type dust collectors include bag type dust collector...

Exhaust gas purification towers generally include acid mist exhaust gas purification tower, FRP exhaust gas purification tower, biological exhaust gas purification tower, PP spray exhaust gas purification tower, etc. Flue gas purification mainly refers to the treatment of industrial waste gas gen...

Time:2021.12.01-12.04 Venue:Jakarta Convention Center, Indonesia ADD.:Jl. Gatot Subroto, RT.1/RW.3, Gelora, Tanahabang, Kota Jakarta Pusat, Daerah Khusus Ibukota Jakarta 10270, Indonesia Range of exhibition Tools: hand tools and power tools, hardware tool cutting tools, metal forming tools, grind...

TIME:2022.03.08-03.11 Venue: Melbourne Convention and Exhibition Centre, Australia Add.:2 Clarendon Street,Southbank,Melbourne, Victoria,Australia, 3205,Australia Exhibition introduction: Australia Melbourne Industrial Machinery Manufacturing Exhibition (National Manufacturing Week: NMW) is Austr...

Natural wind enters from two directions. One direction enters from the air inlet on the top of the cooling tower, passes through the cooler and enters the air duct, and the other direction enters from the air inlet grille and enters the air duct through the pre-cooling filler. The wind from all d...

Natural wind enters the cooling tower from both sides of the cooling tower, passes through the pre-cooling filler and the cooler on the upper part of the cooler, and flows upward in the middle of the cooling tower. The exhaust system discharges the wind to the top of the cooling tower. The spray ...

Natural wind enters the inside of the cooling tower from the inlet grille, flows upward, and discharges the wind to the top of the cooling tower through the exhaust system. The spray pump sucks water from the water tank, passes through the outer spray pipe to the inner spray device, and sprays it...

Lifting structure The transmission path is as follows: the motor drives the high-speed shaft of the reducer through the high-speed shaft coupling, passes through the reducer and increases the torque, and the low-speed shaft passes through the low-speed shaft coupling to drive the reel. The wire ...

Electrical failure. There are many electrical faults. The most common ones are loose control wires, arcing and burning of contactor contacts, etc. Mechanical failure. Mechanical failures are relatively simple, usually due to aging of mechanical parts, excessive wear, etc., change the failurepart...

The working strength of the jib crane is light. The crane is composed of a column, a slewing arm slewing drive device and an electric hoist. The lower end of the column is fixed on the concrete foundation by anchor bolts. The I-beam of the jib can be used to run left and right in a straight line,...